Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 152 / 361

Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
Features and controls 5-87
5
N00593500095
When the BSW switch is pressed while the
ignition switch is turned to the “ON” position
or the operation mode is put in ON, the
indicator (green) will appear on the informa-
tion screen of the multi-information display
and the BSW will enter the standby state.
When the BSW switch is pressed again, the
indicator on the information screen of the
multi-information display will then go out
and the BSW will turn off.
• When the heights of the next lane and
your lane are different.
• Immediately after the BSW has been
turned on.
• Immediately after the engine switch is
turned on.
• Under adverse weather conditions, such
as rain, snow, strong winds, snow or sand
storm.
• When your vehicle becomes too close to
another vehicle.
• While multiple vehicle are overtaking
your vehicle.
• When driving near a pot hole and tram-
line.
• When a surrounding vehicle or an
oncoming vehicle is splashing water,
snow or dirt.
• When driving on a curve including the
beginning and the end of the curve.
• When driving on a road with alternating
up and down steep slopes.
• When driving on a bumpy or rough road.
• When the rear of your vehicle is weighed
down or your vehicle is leaning to the
right or left due to the weight of passen-
gers and luggage or the improper adjust-
ment of tire pressure.
• When the bumper surface around the
radar sensor is covered with dirt, snow
and ice, etc.
WARNING
• When a bicycle carrier or accessory is
installed to the rear of the vehicle.
• When the sensor is extremely hot or cold
(while the vehicle is parked for a long
period of time under a blazing sun or in
cold weather).
CAUTION
 To maintain proper performance of the BSW,
follow the instructions below.
• Always keep the bumper surface around the
sensor clean.
• Avoid impacting the sensor or its surround-
ing area.
• Do not put a sticker on the sensor or its sur-
rounding bumper surface.
• Do not paint the sensor or its surrounding
bumper surface.
• Do not modify the sensor or its surrounding
area.
 If the bumper has experienced an impact, the
sensor may have been damaged and the BSW
may not function properly. Have the vehicle
inspected at an authorized Mitsubishi Motors
dealer.
To operate
WARNING
BK0265500US.book 87 ページ ２０１８年５月８日 火曜日 午後８時７分