Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 150 / 361

Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
Features and controls 5-85
5
N00592200079
The Blind Spot Warning (BSW) is a driving
aid system that alerts the driver when another
vehicle which may not be visible through the
outside rearview mirror is traveling in the
next lane behind your vehicle.
When a vehicle in the next lane is traveling at
same speed or faster in the detection areas,
the Blind Spot Warning light in the corre-
sponding outside rearview mirror will illumi-
nate. If the turn signal lever is operated to the
• Always keep the windshield clean.
If the inside of the windshield where the
sensor is installed becomes dirty or fogged,
contact an authorized Mitsubishi Motors
dealer.
• Do not apply an impact or load on the sen-
sor or its surrounding area.
• Do not put anything including a sticker or
film to the outer side of windshield in front
of or surrounding the area of the sensor.
Also, do not put anything including a
sticker of film to inner side of the wind-
shield under the sensor.
• Do not attempt to detach or disassemble the
sensor.
• If the windshield is misted, remove the mist
from the windshield by using the defogger
switch.
• Maintain the wiper blades in good condi-
tion. Refer to “Wiper blades” on page 9-44.
When replacing the wiper blades, use only
Mitsubishi Motors Genuine parts or equiva-
lent.
• Do not dirty or damage the sensor.
CAUTION
• Do not spray glass cleaner on the sensor.
Also, do not spill liquid, such as a bever-
age, on the sensor.
• Do not install an electronic device, such as
an antenna, or a device that emits strong
electric waves, near the sensor.
• Always use tires of the same size, same
type and same brand, and which have no
significant wear differences.
• Do not modify the vehicle’s suspensions.
 If the windshield in front of the sensor or in
the surrounding area of the sensor is cracked
or scratched, the sensor may not detect an
object properly. This could cause a serious
accident. Turn off the FCM and have your
vehicle inspected as soon as possible at an
authorized Mitsubishi Motors dealer.
If you need to replace the windshield, con-
tact an authorized Mitsubishi Motors dealer.

The sensor emits infrared rays when the
operation mode is in ON. Do not look into
the sensor by using optical goods such as a
magnifying glass. The infrared ray might
injure your eyes.
Laser radar specifications
Laser classification
Max average power 45 mW
Pulse duration 33 ns
CAUTION
Wavelength 905 nm
Divergent angle
(horizon x vertical)
28° x 12°
Laser classification label
Blind Spot Warning (BSW)
(with Lane Change Assist)
(if
so equipped)
BK0265500US.book 85 ページ ２０１８年５月８日 火曜日 午後８時７分