Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 177 / 361

Multi-information display
5-112 Features and controls
5
The operation method is the same as when
the ignition switch or the operation mode is in
OFF.
For further details, refer to “Odometer/Trip
odometer” on page 5-108.
Shows the distance and number of months
until the next periodic inspection.
Refer to “Service reminder” on page 5-116.
Shows the engine coolant temperature.
If the coolant becomes hot, “ ” will blink.
Pay careful attention to the engine coolant
temperature display while you are driving.
Shows the approximate driving range (how
many more miles or kilometers you can
drive). When this driving range falls below
30 miles (50 km), “---” is displayed.
Refuel as soon as possible.
While driving, the momentary fuel consump-
tion is shown with a bar graph.
When the momentary fuel consumption sur-
passes the average fuel consumption, the
momentary fuel consumption is displayed
with a green bar graph.
5- Average fuel consumption display,
momentary fuel consumption display
6- Average speed display, momentary fuel
consumption display
7- Function setting screen
8- Redisplay of a warning display screen
NOTE
 While driving, the function setting screen is
not displayed even if you operate the multi-
information meter switch. Always park the
vehicle in a safe place before operating.
Refer to “Changing the function settings
(With ignition switch or operation mode in
ON)” on page 5-118.

When there is information to be announced,
such as a system fault, the tone sounds and
the screen display is switched.
Refer to “Interrupt display screen (With igni-
tion switch or operation mode in ON)” on
page 5-114.
Odometer/Trip odometer
Service reminder
Engine coolant temperature dis-
play
CAUTION
 If the engine is overheating, “ ” will blink.
In this case, the bar graph is on the red zone.
Immediately park the vehicle in a safe place
and take the required measures. Refer to
“Engine overheating” on page 8-4.
Driving range display
NOTE
 The driving range is determined based on the
fuel consumption data. This may vary
depending on the driving conditions and hab-
its. Treat the distance displayed as just a
rough guideline.

When you refuel, the driving range display is
updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill to a full tank whenever possible.
 When your vehicle is stopped on an
extremely steep hill, the driving range value
may, change. This is due to the movement of
fuel in the tank and does not indicate any
breakdown.

The display setting can be changed to the
preferred units (miles or km).
Refer to “Changing the function settings
(With ignition switch or operation mode in
ON)” on page 5-118.
Momentary fuel consumption dis-
play
BK0265500US.book 112 ページ ２０１８年５月８日 火曜日 午後８時７分