Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 153 / 361

Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
5-88 Features and controls
5
If you turn the BSW ON/OFF, the Rear Cross
Traffic Alert (RCTA) also turns ON/OFF at
the same time.
When the indicator (green) appears on the
information screen of the multi-information
display, if a vehicle is approaching your vehi-
cle in the detection area, the Blind Spot
Warning light in the outside rearview mirror
illuminates.
If the turn signal lever is operated to the side
where the Blind Spot Warning light is illumi-
nated, the Blind Spot Warning light will blink
and the system will beep 3 times to alert the
driver.
N00592400042
If a problem occurs with the system, a visual
warning specific to the type of the problem is
given together with an audible alarm.
The warnings are combined with the Rear
Cross Traffic Alert (RCTA) system.
NOTE
 Approximately 4 seconds after the ignition
switch is turned to the “ON” position or the
operation mode is put in ON, the indica-
tor (green) appears on the information screen
of the multi-information display.
 When the operation mode is set to OFF, the
selected condition (BSW ON/OFF) just
before setting to OFF is retained.
 The BSW operates when all of the following
conditions are met.
• The ignition switch is turned to the “ON”
position or the operation mode is put in ON.
• The selector lever is in positions other than
“P” (PARK) and “R” (REVERSE).
• The speed of your vehicle is approximately
6 mph (10 km/h) or higher.
When the sensor detects an
approaching vehicle
NOTE
 The Blind Spot Warning light in the outside
rearview mirror may come on or blink in the
following conditions.
• When driving very near the guardrail or the
concrete wall.
• When driving near the entrance and outlet
of a tunnel or very near the wall or near the
evacuation area inside the tunnel.
• When turning at an intersection in a town
area.
• Under adverse weather conditions (rain,
snow, sand storm etc.).
• When driving while your vehicle is blowing
up water, snow, sand, etc., on the road.
• When driving near a curb, pot hole and
tramline.

Set the BSW to OFF when towing.
 The Blind Spot Warning light in the outside
rearview mirror may not be visible due to
strong direct sunlight or the glare from the
headlights of vehicles behind you during
night driving.
System problem warning
NOTE
BK0265500US.book 88 ページ ２０１８年５月８日 火曜日 午後８時７分