Mitsubishi MOTORS Outlander Sport 2019, Owner'S Manual

Page: 232 / 361

HomeLink® Wireless Control System (if so equipped)
Features and controls 5-167
5
N00584600032
 Some garage door openers manufactured
after 1995 have “rolling code protection”.
To program a garage door opener
equipped with “rolling code protection”;
you will need to access the garage door
opener motor to press the motor’s “Learn”
or “Smart” buttons. For convenience, use
a ladder and another person to assist you.
 It is recommended that a new battery be
placed in the hand-held transmitter of the
device being programmed to HomeLink
®
for quicker training and accurate trans-
mission of the radio-frequency signal.
N00584700075
To program HomeLink
®
to operate a garage
door, gate, or entry door opener, home or
office lighting, you need to be at the same
location as the device.
1. Press the HomeLink
®
button that you
would like to program. The indicator light
(A) will flash orange slowly.
2. Position the end of your hand-held trans-
mitter (B) 1 to 3 inches (2 to 8 cm) away
from the HomeLink
®
button while keep-
ing the indicator light in view.
 You can program a maximum of 3 devices.
To change or replace any of the 3 devices
after it has been initially programmed, you
must first erase the current settings.
See “Cleaning the programmed information”
on page 5-170 or “Reprogramming a single
HomeLink
®
button” on page 5-171.
1- HomeLink
®
button 1
2- HomeLink
®
button 2
3- HomeLink
®
button 3
NOTE Before programming Home-
Link
®
Programming a new Home-
Link
®
NOTE
 You do not need to continue holding the
HomeLink
®
button.

If the indicator light does not flash, refer to
“Cleaning the programmed information” on
page 5-170.
BK0265500US.book 167 ページ ２０１８年５月８日 火曜日 午後８時７分