Mitsubishi Electric NZ2GF2B-60TCRT4, User Manual

Page: 299 / 388

297
APPENDICES
A
Appendix
1 Det
ails of
Rem
ot
e I
/O
S
ignals
Appendix
1.
2 Rem
ot
e
out
put
signals
(6) Default setting registration instruction (RY16)
By turning on this signal, a value in remote buffer memory areas returns to a default value according to the
control output cycle unit selection setting and control mode setting.
Target data of the default return are module-based parameter data in parameter area (address: 100H to 4FFH),
and station-based control data and module based control data in module control data area (address 1000H to
14FFH). For details, refer to the following.
•

Page 49, Section 3.7
After the data writing is completed, Default value write completion flag (RX16) turns on.
(a) Execution timing of this signal
Turn on the signal while the module is stopped (when CH  Operation monitor (RX11 to RX14) is off). The
value does not return to the default even if the signal is turned on during module operation (when CH 
Operation monitor (RX11 to RX14) is on). (An error does not occur.)
(b) Timing of setting change to a default
The setting is automatically changed to the default by turning on the signal.
After setting changes of remote buffer memory areas, turning on Initial data setting request flag (RY9) or During operation
setting change instruction (RY10) is required to reflect the change. However, if Default setting registration instruction (RY16)
is turned on, the change is reflected without turning on these signals.
Therefore, after the setting change to the default, check that a set value is correct and start the control.
(c) When a control mode change error has occurred (error code: 000DH)
Default setting registration is performed according to the value stored in Control switching monitor (address:
602H).
Common