Mitsubishi Electric MELSERVO MR-J4-A-RJ Series, Instruction Manual

Page: 63 / 416

3. DISPLAY AND OPERATION SECTIONS
3 - 2
3.1 Display sequence
Press the "MODE" button once to shift to the next display mode. Refer to section 3.2 and later for the
description of the corresponding display mode.
Display mode transition Initial screen Function Reference
Status display
Diagnosis
Point table setting
Basic setting
parameters
Gain/filter
parameters
Extension setting
parameters
Extension setting 2
parameters
Extension setting 3
parameters
I/O setting
parameters
button
MODE
One-touch tuning
Positioning setting
parameters
Linear/DD motor
setting parameter
Option setting
parameters
Alarm
Servo status display.
For the point table and program,
is displayed at power-on.
For indexer,
will be displayed.
(Note)
Section 3.2
One-touch tuning
Select this when performing the one-touch
tuning. MR-J4-_A_
(-RJ) Servo
Amplifier
Instruction
Manual
section 6.2
Sequence display, drive recorder
enabled/disabled display, external I/O signal
display, output signal (DO) forced output, test
operation, software version display, VC
automatic offset, servo motor series ID
display, servo motor type ID display, servo
motor encoder ID display, teaching function Section 3.3
Current alarm display, alarm history display
and parameter error No./point table error No.
display Section 3.4
Display and setting of point table data.
The screen is displayed only in the point table
method, and is not displayed in other control
mode. Section 3.5
Display and setting of basic setting
parameters. Section 3.6
Display and setting of gain/filter parameters.
Display and setting of extension setting
parameters.
Display and setting of I/O setting parameters.
Display and setting of extension setting 2
parameters.
Display and setting of extension setting 3
parameters.
Display and setting of linear/DD motor setting
parameters.
Display and setting of option setting
parameters.
Display and setting of positioning control
parameters. Section 3.7