Meridian Link/Customer Controlled Routing, Installation And Upgrade Manual

Page: 400 / 595

382 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Section 7: To update Meridian Link from Release 5 to
Release 5C
When you update Meridian Link from Release 5 to Release 5C, the release
or issue of the BOS changes.
¥ Perform Procedure 2: Start the update process.
¥ Depending on the type of SBC card installed, perform one of the
following:
Ñ Procedure 5: Load the operating system tape on an Application
Module with an MVME147 card
Ñ Procedure 6: Load the operating system tape on an IPE Module or
an Application Module with an MVME167 card
¥ Perform Procedure 7: Reboot and go through setup.
¥ Perform Procedure 8: Load the application software from tape.
¥ Perform Procedure 9: Restore configuration files and data files from the
backup tape to customize your system.
¥ Perform Procedure 10: Verify the installation to confirm that the
installation is complete and correct.
¥ Perform Procedure 11: Back up configuration files and data files to
back up the customized new release.
Section 8: To update Meridian Link from Release 5 to
Co-residency
If you have Meridian Link Release 5 and want to upgrade to
co-residency, you must install the application. Then you must enter a
keycode to activate CCR and Meridian Link.
To do this:
¥ Perform Procedure 2: Start the update process.
¥ Perform Procedure 3: Load the application software from tape.