406
Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 3: Load application software from tape (continued)
If you did not purchase CCR but you have enabled NSE, go to step
16. For more information about Ethernet connections, refer to
ÒInstalling Ethernet LAN supportÓ in the ÒMeridian Link/CCR interface
cabling.Ó
If you have purchased CCR, go to step 14.
Figure 131
CCR customer number prompt
Please enter the CCR customer number (0-99):
14
You are prompted to enter your customer number (Figure 131). Type
the customer number and press [Return].
Note:
A two-minute pause occurs at this point before the following
messages appear.
Figure 132
Ethernet connection prompt
Installing NSE R3V7.1. Please wait.
Is your module connected to the Ethernet (y/n) ?
15
You are asked whether your Application Module or IPE Module is
connected to Ethernet (Figure 132).
For more information about Ethernet connections, refer to Chapter 9,
ÒMeridian Link/CCR interface cabling.Ó
If your module is not connected to Ethernet, type
n
and press
[Return]. Go to step 19.
If you are connected to Ethernet and
you plan to use it in the near
future,
type
y
and press [Return]. You see a message asking you to
wait. Then you see more installation messages (Figure 133). Go to
step 16.
Summary of Contents for Link/Customer Controlled Routing
