Meridian Link/Customer Controlled Routing, Installation And Upgrade Manual

Page: 485 / 595

Chapter 14: Software installation, upgrade, and update procedures 467
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Procedure 8: Load the application software from tape (continued)
ATTENTION
If you disable Ethernet support, you must perform a complete
reinstallation of the base operating system and application(s) before
you can reenable Ethernet support.
Note: A two-minute pause occurs at this point before the following
messages shown in Figure 243 appear.
Figure 243
Software install messages 2
Configuring your system for NSE. Please wait.
/usr/src/uts/m68k/sysgen/sysgen -l /usr/src/uts/m68k/sysgen -big
make -f io.mk MAKE=make FRC= DASHG= DASHO=-O INCRT=/usr/include
LIBDIR=../cf SYS= CFLAGS= -O -I/usr/include -DLAI -DINKERNE
L -DSTREAMS -DBRIDGE CPU=m68k CC=/bin/pcc/cc
make -f scsi.mk "MAKE=make" "CC=/bin/pcc/cc" "FRC=" "INCRT=/usr/include"
"DASHO=-O" "CFLAGS=-O -I/usr/include -DLAI -DINKER
.
.
.
Warning: ./config.h: 358: NBLK4 redefined
rm -f sysV68 sysV68.nm
ld -o sysV68 ld.VME131 m68kvec.o low.o conf.o lib.io lib.ml lib.os
lib.s5 lib.bpp lib.fpack lib.nosrc lib.fpsp lib.du lib.tc
pip lib.nfs lib.bppv2 lib.c37x lib.kdb lib.lnc lib.nsedebug lib.sbc lib.scsi
lib.wan lib.x25 lib.stub lib.io lib.ml lib.os
lib.s5 lib.bpp lib.fpack lib.nosrc lib.fpsp lib.du lib.tcpip lib.nfs lib.bppv2
lib.c37x lib.kdb lib.lnc lib.nsedebug lib.sbc lib.scs
i lib.wan lib.x25 lib.stub
mcs -da "SYSTEM V/68 - R3V7" sysV68
chmod 755 sysV68
../kdb/kdbnm -q sysV68
../kdb/kdbnm: not enough space for symbol table
../kdb/kdbnm: need total of 145908 bytes at k_symtab
../kdb/kdbnm: 135168 bytes were reserved for symbols, 135168 bytes were used
sysV68 made.