Meridian Link/Customer Controlled Routing, Installation And Upgrade Manual

Page: 426 / 595

408 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 3: Load application software from tape (continued)
Figure 134
Module name prompt
ADD MODULE NAME AND ADDRESS TO TCPIP TRANSPORT PROVIDER DATABASE
If you are not sure how to answer any prompt, type Ò?Ó for HELP.
Your moduleÕs system is currently the default name. We recommend that you change
it to avoid possible name conflicts.
Enter the MODULE NAME to be added to the tcpip transport provider database
(?, or module name):
16 You are prompted for the name of the Application Module or
IPE Module (Figure 134). (The term Òmodule nameÓ refers to an
Ethernet host computer, which in this case is the Application Module
or IPE Module.) Type the module name and press [Return]. The
module name must not exceed eight alphanumeric characters. For
more information about module names, consult your network
administrator.
Figure 135
Module address prompt
Enter the MODULE ADDRESS to be added to the tcpip transport provider database
(?, or module address):
17 You are prompted for the address of the Application Module or IPE
Module (Figure 135). Type the module address and press [Return].
The module address must be four numbers separated by periods,
such as Ò12.234.67.89Ó. For more information about module
addresses, consult your network administrator.
Figure 136
Reenter prompt
If you made any mistakes in entering the module name and IP address, you can
correct them. Would you like to re-enter the module name or IP address? [y,n]: