Chapter 12: Meridian 1 configuration for Meridian Link/CCR
299
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Configure ESDI port (X11 Release 17)
The IPE Module or Application Module is connected to the Meridian 1
through a port on a QPC513 ESDI card (vintage G or later) or an NTAK02
SDI/DCH card (Option 11, IPE Module only). The port must have the AML
identified (VSID 0Ð15). Define the ESDI port and its characteristics by
responding to the following prompts in
LD 17.
Options 21Ð81 ESDI configuration
Table 106
LD 17ÑConfigure ESDI port (Options 21Ð81)
Prompt
Response
Comment
REQ
CHG
Create or change information in the
database
TYPE
CFN
Configuration record data block
PWD2
<cr>
ISDN
<cr>
PARM
YES
Change a parameter
NCR
26Ð2047,
5000
Increment the current value by the value
used for CSQI and CSQO. See those
prompts described later in this table.
Note:
The Meridian 1 must be reinitialized if
NCR is changed.
CEQU
<cr>
OVLY
<cr>
IOTB
YES
Change I/O terminals or devices
HIST
<cr>
ADAN
NEW TTY x
Add ESDI on port x
ESDI
YES
Port is on an ESDI card
SYNC
YES
Synchronous mode
ÑcontinuedÑ
Summary of Contents for Link/Customer Controlled Routing
