Meridian Link/Customer Controlled Routing, Installation And Upgrade Manual

Page: 340 / 595

322 Chapter 12: Meridian 1 configuration for Meridian Link/CCR
553-3202-210 Standard October 1998
LD 14ÑTrunk data block
The pre-specified DN (auto-terminate DN) where all incoming calls on a
DNIS route auto-terminate is defined in this program.
Note: The ATDN must be defined prior to configuration.
Table 116
LD 14ÑConfigure auto-terminating DN
Prompt Response Comment
REQ NEW, CHG Create or change data in the database
TYPE aaa Approved trunk types for this action
TN l s c u Terminal number for the trunk
XTRK EXUT, XCOT,
XDID, XEM, XUT,
XFEM Extended trunk
CUST xx Customer number associated with this
trunk, as defined in LD 15.
NCOS <cr>
RTMB 0Ð511
0Ð254 Route and member number
ATDN xxxx Auto-terminating DN. Must be ACD DN
or CDN.
Note: The only auto-terminating trunk
types are DID and TIE.
SIGL DX2, DX4, EAM,
EM4, GRD, LDR,
LOP, OAD Trunk signaling
STRO DDL, IMM, OWK,
WNK Start Arrangement Outgoing
STRI DDL, IMM, OWK,
WNK Start Arrangement Incoming
Ñ continued Ñ