Meridian Link/Customer Controlled Routing, Installation And Upgrade Manual

Page: 434 / 595

416 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 5: Load the operating system tape on an Application Module
with an MVME147 card (continued)
Figure 148
SCSI bus reset prompts
Reset Local SCSI Bus (Y, N) N?
y <cr>
Automatic reset of known SCSI Buses on RESET (Y, N) = Y?
<
cr>
Cold/Warm Reset flag (C, W) = C?
<cr>
Execute Soft Reset (Y, N) N?
<cr>
11 When the Ò147-Diag>Ó prompt appears, type env and press [Return].
The environment prompts appear.
12 Answer the prompts as indicated in Figures 149, 150, or 151,
depending on the firmware installed in your system. The firmware
release appeared in the start-up messages shown in step 3.
Figure 149
Environment prompts for firmware revision 2.2
Bug or System environment [B,S] = S?
<cr>
SYSTEM V/68 or VERSAdos operating system [S,V] = S?
<cr>
Execute/Bypass SST Memory test [E,B] = E?
b <cr>
Set VME Chip:
Board ID [0-FF] = $00?
<cr>
GCSR base address [0-0F] = $0F?
<cr>
Utility Interrupt Mask [0-FE] = $00?
<cr>
Utility Interrupt Vector [$20-$30] = $0180?
<cr>
Figure 150
Environment prompts for firmware revision 2.3
Bug or System environment [B,S] = S?
<cr>
Execute/Bypass System Memory Sizing [E,B] = B?
<cr>
Ê
Execute/Bypass SST Memory test [E,B] = B?
<cr>
Set VME Chip:
Board ID(def is 0) [0-FF] = $00?
<cr>
GCSR base address offset(def is 0F) [0-0F] = $0F?
<cr>
Utility Interrupt Mask(def is 0) [0-FE] = $00?
<cr>
Utility Interrupt Vector number(def is 60) [8-F8] = $60?
<cr>
VMEbus Interrupt Mask(def is FE) [0-FE] = $FE?
<cr>