MediSono P25 EXP, User Manual

Page: 98 / 214

6 Acquiring Images
86 Basic User Manual
Figure 6-6 CFM-Mode Imaging Screen
3. Adjust color flow ROI.
−
Move the trackball to position color flow ROI.
−
Press the confirm key on the control panel to adjust the size of color flow ROI.
−
Press the confirm key again to reposition color flow ROI.
4. Optimize the CFM-mode image. For details, refer to Section 6.3.4 Optimizing CFM/
PDI/TDI Mode Images.
5. Press the CFM key again to exit the screen.
6
�
3
�
2 PDI Mode
PDI (Power Doppler Imaging) is a color flow imaging technology which adds the flow
signal in the CFM-mode image. PDI uses the number and amplitude of red blood cells
going through in the flow to create the color-coded imaging. A flow with slow velocity
and small rate can be displayed in PDI. Therefore, a flow with a higher sensitivity can be
detected without overlaying any flows with high velocity.
The direction of flow, the flow velocity and flow properties cannot be reflected in the PDI-
Mode image.
Perform the following steps to acquire PDI-mode images:
1. Optimize a B-mode image.
2. Press the CFM key on the control panel, and then tap PDI on the touch screen to enter
the PDI mode.
2D Imaging
Color Flow ROI
PWR 70
FRQ 2.2
15
cm/s
1.0
86
255
1/50
-9
10
FRQ 3-4.8
D
16.5cm
C
PRF
WF
GN
C/P
5
PWR 70
9
0
47
3/1
255
3/30
B
FPS
D/G
GN
I/P