MediSono P25 EXP, User Manual

Page: 136 / 214

124 Basic User Manual
9 3D Imaging
9
�
1 Acquiring 3D Images
The following description uses 3D imaging performed with the VC6-2 probe as an
example.
Perform the following steps to acquire 3D images.
1. Enter the patient information, select the VC6-2 probe and an exam type (such as the
obstetric exam used throughout this chapter) to enter the B mode.
2. Optimize imaging parameters in the B mode.
3. Apply adequate gel on the patient.
4. Acquire a B-mode image of high quality.
5. Tap 3D/4D on the touch screen to enter the inactivated 4D mode.
NOTE:
When using a volume probe, you can set the default inactivated 3D or 4D mode.
For details, refer to Section 4.1.4 Defined-Key Settings.
When using a non-volume probe, you should press the
Freeze
key and tap
FreeHand 3D to enter the inactivated 3D mode.
6. Tap the 3D tab to enter the inactivated 3D mode.
The 2D imaging with ROI and sample line is displayed in the inactivated 3D mode,
only the data in ROI is acquired for 3D imaging.
Figure 9-1 Inactivated 3D Imaging Screen
7. Adjust ROI and sample line.
You can press the confirm key to select the desired status icon.
−
If is highlighted, use the trackball to position the ROI.
Status Icon
Sample Volume
Sample Line
Angle 55
Quality M
D 16.5cm
Anchor
ROI
PWR 70
FRQ 3-4.8
2D Imaging
47
3/1
255
3/30
FPS
D/G
GN
I/P