SW4000 USER’S MANUAL
62 VER5.13
2. Press
ENTER
,
Y window displays the former setting.
“0” means deep compensation is disabled;
“1” means deep compensation is enabled;
3. Press
0
or
1
to change mode of depth
compensation;
4. Press
ENTER
to confirm your change and exit.
7.14
Setting the Slope Machining Parameter
Parameter can be set in two ways in slope machining :
A Set the step of second axis (Z STEP) in one plane: for XY plane, set
the step of Y axis; for YZ plane and XZ plane set the step of Z axis.
B Set MAX CUT.
Default setting: the step of the second axis (Z STEP).
Set the slope machining parameter MAX CUT.
STEPS:
1. Enter “SETUP” and press
or
until message
window displays “SLOP.MODE”;
2. Press
ENTER
,
Y window displays the former parameter mode;
Press
1
to select MAX CUT parameter mode;
Note: Press
0
to select Z STEP parameter mode.
4. Press
ENTER
to save the change and exit this item.
Press
AC
to cancel your change and exit this item.
Z
S
T
E
P
M
A
X
C U
T
