SW4000 USER’S MANUAL
26 VER5.13
NOTE: If “0” or “1” is input as hole number, DRO will not
accept and remain user to input again.
6. Message window displays “HOLE 1”;
Move the machine table until “0.000”appears in X
window and Y window, it is the center of the first hole
to punch.
7. After finishing the first hole, press
, and the
message window displays “HOLE 2”;
Move the machine table until “0.000” appears in X
and Y window, and then you can punch the second
hole at this point.
NOTE: Press
or
to transform among holes.
8. Process the holes 3rd –6
th
in the same way.
9. Press
to return normal display state when
finishing processing.
NOTE:
In the course of BHL processing, you can press
(three axes display) or
X
Y
(two axes display) to
leave this function temporarily and return normal display of X, Y, Z axis in order to check the position which
the DRO calculated. Then press
(three axes display) or
X
Y
(two axes display) again to return BHL
function.
4.3
ARC Processing
This function is only for SW4000-2, SW4000-3.
It is waste to using numerical control lathe to process arc in the simple product or small production.
This function makes it convenient to process arc with normal lathe. Parameter “MAX CUT” is the arc
length each process. The smaller the MAX CUT, the more smooth the arc plane and the longer processing
time.
A. Process XZ, YZ plane
There are 8 modes as the following when processing arc in XZ or YZ plane:
