SW4000 USER’S MANUAL
56 VER5.13
In common case, the display value is the distance between lathe tools and the coordinate origin. This
display mode is called MODE R. When process cylinder given diameter measurement, diameter is the
double distance between lathe tool and coordinate datum. The DRO will display the diameter in MODE D
Default mode: mode R.
STEPS:
1. Enter “SETUP” and press
or
until the message
window displays “R OR D”;
2. Press
ENTER
,
X window, Y window and Z window displays “0” or “1”
separately.
“0” is mode R, which means the display value equals the
actual measurement. “1” is mode D where the display value
equals the double actual measurement.
Message window displays “SEL AXIS”, which indicates the
next step is to select axis;
3. Select axis
Press
X
to change the R/D mode of X axis;
Press
Y
to change the R/D mode of Y axis;
Press
Z
to change the R/D mode of Z axis;
4. Press
ENTER
to save your change and exit;
Press
AC
to cancel your change and exit.
7.6
Setting Z axis Dial
Z axis Dial should be set if Z axis is emulated for SW4000-2 and only install linear scale for X, Y axis.
Z axis Dial means the distance the Z axis travels when screw runs a revolution.
Default value: 2.5mm
Set Z axis Dial 2.4 mm:
1. Enter “SETUP”, then press
or
until message
window displays “Z DIAL”;
2. Press
ENTER
,
Y window displays the former Z axis Dial;
Message window displays “Z DIAL”;
