SW4000 USER’S MANUAL
VER5.13 29
8. Set Tool diameter.
Message window displays “TOOL DIA”;
Y window displays the former preset diameter
Press
6
ENTER
in turn to enter the tool diameter.
9. Set the feed step.
Message window displays “MAX CUT”;
Y window displays the former feed step.
Press
0
.
5
ENTER
in turn to input the feed step.
NOTE: If “0” is inputted as the feed step, the DRO will not accept
and wait for inputting another data.
10. Process ARC
Message window displays “POIN 1”. Process when
the “0.000” appears in X window and Y window. Then
you have finished the first point. Press
to switch
to the second point and repeat the same step. Process
in this way until the message window displays “POIN
74”. Pressing
or
can select processing
point.
11. Press
to exit ARC processing after machining is over.
NOTE:
○
○
○
○
1
In the ARC process, pressing
(three axes display) or
X
Y
(two axes display) can leave this function
temporarily to return normal display of X, Y, and Z axis in order or check the position the DRO has
calculated. Press
(three axes display)
或
或
或
或
X
Y
(two axes display) to return ARC function.
②
②
②
②
Processing
or
can switch among the parameters in the course of the presetting parameter.
Example 2:
Process the ARC EF as the figure from point E to point F.
Parameters are set as following:
Machine plane: XZ
TYPE: 4
RADIUS: Actual radius of the arc
TOOL DIA: 0 (flat-bottomed tool)
MAX CUT: preset as the costumer
B
A
O
E
F
