SW4000 USER’S MANUAL
52 VER5.13
7.2
Setting the type of DRO
Because SW4000 series DROs (two axes or three axes DRO) share the same software and their
functions have some differences. DRO type must be set before use. ALL CLS has no effect on type of
DRO.
1. Enter “SETUP” and press
or
until “SEL SYS”
appears in message window;
2. Press
ENTER
, then Y window displays “2” or “3”.
“2” means the DRO type is SW4000-2;
“3” means the DRO type is SW4000-3 or SW4000E.
3. If press
2
, Y window displays “2”;
If press
3
, Y window displays “3”;
4. Press
ENTER
to save your selection and exit this item;
Press
AC
to cancel your operation and exit this item;
7.3
Setting Positive Direction for Counter
If the linear scale is installed as the figure
(facing operators):
Direction
“
0” means the display value
will increase when scale moves from right to
left and decrease when scale moves from left
to right.
Direction
“
1” means the display value will increase when scale moves from left to right and
decrease when scale moves from right to left.
The counting direction of the scale is set by the erector, and the operator had better not change it.
Default: 0
STEPS:
1. Enter “SETUP” and then press
or
until
“DIRECT” appears in message window.
2. Press
ENTER
to enter direction setup;
X window, Y window and Z window display “0” or
