SW4000 USER’S MANUAL
32 VER5.13
You can also press
N
O
-1
(two axes display) or
N
-1
(three axes display) to switch among XY plane, YZ plane
or ZX plane.
4. Enter INCL.ANG.
Message window displays “INCL ANG”; Y window
displays the former INCL.ANG.
Press
4
5
ENTER
in turn.
5. Enter MAX.CUT.
Message window displays “MAX CUT”; Y window
displays the former MAX.CUT.
Press
1
.
2
ENTER
in turn;
NOTE: If “0” is inputted as MAX CUT, DRO will not accept
and wait for another data.
6. Processing
Message window displays “POIN 1”;
Processes slop when the “0.000” appears; then press
to process the next point.
7. Press
or
to select point.
8. Press
to return normal display state after processing is over.
Note: For SW4000-2, it is not installed with Z-axis, please press
or
to simulate position
of Z-axis,
simulate moving to the former process point, and
simulate moving to
the next process point.
Steps:
1: Set Z axis dial in internal system setup;
2: Before machining, align the start point Z point with lathe, then set Z axis as “0.000”;
3. While machining XZ plane, X window display position of X axis, X axis is finished when
“0.000” appears in X window; In Y window, the former 2 number indicates number of
dial, and the following 5 number indicates scale number of dial, which means that
machining to this scale for current point.
While machining YZ plane, Y window display position of Y axis, and when this window
displays “0.000”, which indicates the machining is finished in Y direction; In X window, the
former 2 number indicates number of dial, and the following 5 number indicates scale
number of dial, which means that machining to this scale for current point.
