SW4000 USER’S MANUAL
VER5.13 59
3. Press
0
or
1
to set the RELAY MODE.
4. Press
ENTER
to confirm your setting and exit
“RELAY.MODE”;
Press
AC
to cancel your change and exit
“RELAY.MODE”.
7.9
Setting the EDM Mode
SW4000 provides 7 EDM modes. For detail information, please refer to chapter five. EDM mode must
be set before EDM machining.
Default mode: MODE 1.
Set the EDM mode to mode 3.
STEPS:
1. Enter “SETUP”, then press
or
until message
window displays “EDM MODE”;
2. Press
ENTER
, then Y window displays the former EDM
mode;
3. Press
3
to change the mode;
Press the number key which you want to set the mode.
4. Press
ENTER
to confirm your setting and exit
“EDM.MODE” setup.
Press
AC
to cancel your change and exit “EDM.MODE”
setup;
7.10
Setting the Input Mode in SDM Coordinate
WE600E series DRO provides two inputting data mode in SDM coordinate:
MODE 0 (Normal inputting mode): the data the DRO accept equals the inputted data;
MODE 1 (Special inputting mode): the data the DRO accept equals the negative of the inputted number.
