SW4000 USER’S MANUAL
VER5.13 23
window. It is the position to process a hole.
Example: Machine holes on circumference as the figure (E).
RADIUS 20mm
ST.ANGLE 0º
END.ANGLE 300º
HOLE NUM 6
DIRECT 0
STEPS:
1. Set display unit to metric in normal state;
Move the machine table until the machine tool is aligned with
the center of the circle, then zero X axis, Y axis.
2. Press
to enter Bolt Hole Circle function.
If all parameters have been set, press
ENTER
to process directly.
3. Input radius
Y window displays the formerly preset radius; message window
displays “RADIUS”.
Press
2
0
ENTER
in turn.
NOTE:
If “0” is inputted as the radius, the DRO will be requested to input again.
If incorrect parameter has been input and you haven’t pressed
ENTER
, press
AC
to cancel and input
again; if you have pressed
ENTER
and begin to set another parameter, you should press
to return
RADIUS set and input again. Other parameters can be deal with in the same way.
4. Input ST.ANGLE
Message window displays “ST.ANGLE”; Y window displays
the former preset starting angle.
Press
0
ENTER
in turn;
5. Input ending angle
Message window displays “END.ANGLE”; Y window
displays the former angle.
Press
3
0
0
ENTER
in turn.
f o r m e r s t a r t i n g
a n g l e
f o r m e r e n d i n g
a n g l e
