SW4000 USER’S MANUAL
14 VER5.13
current SDM number is 776.
If the current SDM number is 777 and the message window displays “SDM 777”,
press
, then the message window will displays “SDM
778”, which means the current SDM number is 778.
If a work-piece as the figure is to be machined where the datum plane is
plane E, the coordinate can be set as the following steps:
1. Return normal display state with ABS coordinate;
2. Move the machine table until the lathe tool is aligned with
plane E, then zero X axis;
3. Move the machine table until the lathe tool is aligned with the plane
D. Change SDM number to SDM
000, and press
to zero
Ｘ
axis. Then the NO.000 SDM coordinate’s datum is set at plane D.
4. Move the machine table until the lathe tool is aligned with plane C,
press
to change SDM to SDM 001, and then press
to zero
X axis, and the SDM 001 with the datum plane C is set.
5. Move the machine table until the lathe tool touches the plane B, the
DRO will display as the right.
6: Move the machine table until the lathe tool touches the plane A, the
DRO will display as the right.
2.8
Clear All SDM Datum
Function: Clear the Datum of all SDM 0 - 999. After clearing, the display value in SDM coordinate is
equal to the value in ABS coordinate.
STEPS:
1. Return normal display state;
2. Press
ABS
INC
and
AC
simultaneously for 2 seconds, and the message window displays “CLS
SDM” and flashes, which means it is clearing now. About ten seconds later, the clearing is
completed and “CLS OK” is displayed in message window temporary and DRO return normal
display state.
C
A
B
D
E
