SW4000 USER’S MANUAL
10 VER5.13
Press
to zero Y axis.
2.3
Preset Data to designed axis
Function: Preset a value to current position for a designed axis in normal display state.
NOTES: 1 Axis can not be preset while the DRO is in other states (e.g. calculating function or special function).
DRO should return normal display state before presetting data.
2 Axis can be preset in ABS/INC/SDM state.
3 In SDM state, input mode “0” means that the display value is equal to the enter value; input mode
“1” means that the display value is equal to the negative of enter value.
4 The range of input value is that the minimum value to the maximum value which could be displayed
in the designated window.
Example: Machine the work-piece from the figure (a) to figure (b), and the plane C
is the datum and counting direction is right.
STEPS:
1.
Move the machine table, and align the lathe tool to plane B.
2
Return normal display state;
3
Press
X
, “0” is flashing in X window, waiting for entering a data;
4
Press
1
0
+-
in turn, which means the preset data is “-10”;
If incorrect value is inputted: press
AC
to cancel and input again;
NOTE: If in SDM state and SDM input mode is “1”,
+-
needn’t be inputted.
Otherwise
+-
must be inputted.
5.
Press
ENTER
to confirm the data that your input and end
presetting it to X axis;
6.
Moving the machine table until “-28.000” is displayed in X window.
Now it is the position of plane A.
7.
Y axis, Z axis can be preset in the same way.
