SW4000 USER’S MANUAL
28 VER5.13
STEPS:
1. Set display unit is metric, and the LED of the
shrinkage is off.
2. Move the machine table until the lathe tool is
aligned with point A, then zero X axis and Y axis;
3. Enter ARC processing state;
Press
to enter ARC processing state.
If all parameters have been set: press
ENTER
to process directly.
4. Select machine plane;
Press
X
ENTER
to select XY.
NOTE:
X
indicates XY plane;
Y
indicates YZ plane;
Z
indicates ZX plane;
You can also press
N
O
-1
(two axes display) or
N
-1
(three axes
display) to switch plane among XY plane, YZ plane and ZX plane.
5. Select processing mode:
Message window displays “TYPE 1-8”, and Y window
displays the former processing mode;
Press
3
ENTER
in turn to select mode 3, and then
enter ARC type;
6. Select T + TOOL mode:
Press
+
ENTER
to select the external arc processing;
NOTE:
+
indicates T + TOOL mode (external arc processing);
-
indicates T – TOOL mode (internal arc processing).
7. Set ARC radius
Message window displays “RADIUS”, and Y window
displays the former arc radius;
Press
2
0
ENTER
in turn to input the arc radius.
NOTE: If “0” as the arc radius is input: the DRO will display error
message and wait another number.
