SW4000 USER’S MANUAL
12 VER5.13
4. Move the machine table until “0.000” is displayed in X
window and Y window. The position (where the lathe tool
is) is the work-piece’s center.
Note: 1. If you do other operation after axis half, please press
1
2
,
will cancel above operation,
and X-axis display value return to normal.
2. It is invalid to mid-point calculation while axis is encoder.
2.6
Set the Shrinkage Mode
Function: With this function, you can process the mould tools according to the dimension of the finished
products without calculating dimension separately.
display value = actual value x shrink ratio.
STEPS:
A. unshrinkage
shrinking
1. DRO returns normal display state;
2. Press
and don’t release. The Y window
displays the current shrinkage ratio, the message
window displays “SURE AGN”, which means
you need to confirm once again.
3. Press
ENTER
to enter shrinkage state; press any
other key to return former state.
NOTE: I
should not be released and press
ENTER
simultaneously to enter shrinkage state;
LED of shrinkage flashes in shrinkage mode;
II You can view the shrink ratio by making use of this function: press
will display shrink ratio of Y
axis; Then press any key can return normal state;
III The signal light of shrink ratio will flicker while in shrinkage.
B. shrinkage
unshrinking.
1. DRO returns normal display state;
2. Press
, now DRO is in unshrinking mode, LED of shrinkage is off;
s h r i n k a g e
r a t i o
