SW4000 USER’S MANUAL
VER5.13 25
LINE ANG Line angle (angle between the line and the positive X axis)
HOLE NUM Number of holes
DRO will calculate the positions of the hole after all the parameters have been entered. Press
or
to select the No. of hole and move the machine until “0.000” is displayed in X window and Y
window. It is the position of hole to machine.
Example:
LINE DIS 150mm
LINE ANG 30º
HOLE NUM 6
STEPS:
1. Set display unit to metric and the shrinkage is not
taken into consideration.
Move the machine table until the machine tool is
aligned with the center point of the first hole, and
zero X axis, Y axis.
2. Press
to enter BOLT HOLE LINE function;
If all parameters have been entered, press
ENTER
to start processing directly.
3. Input line distance.
Y window displays the former preset line distance,
and the message window displays “LINE DIS”.
Press
1
5
0
ENTER
in turn;
NOTE: If “0” is input as the line distance: the DRO will not
accept and remind the operator to input again.
4. Input line angle.
The message window displays “LINE ANG”; Y
window displays the former preset line angle.
Press
3
0
ENTER
in turn.
5. Input the number of hole.
Message window displays “HOLE NUM”, Y
window displays the former preset hole number.
Press
6
ENTER
in turn, processing begins.
f o r m e r p r e s e t
d i s t a n c e
former pressetted angle
former presetted hole
number
X
Y
