SW4000 USER’S MANUAL
24 VER5.13
6. Input the number of hole.
Message window displays “HOLE NUM”; Y window
displays the former number.
Press
6
ENTER
in turn.
NOTE: If “0” or “1” is inputted as the number of holes, the DRO
will point out this mistake and remind inputting again.
7. Input angle direction.
Message window displays “DIRECT”, Y window
displays the former preset direction;
Press
0
ENTER
in turn;
8. Message window displays “HOLE 1”;
It is the position of the first hole to punch where the
“0.000” is displayed in X window and Y window by
moving the machine table.
9. After finishing the first hole, press
Message window displays “HOLE 2”;
Move the machine table, the “0.000” is displayed in X
window and Y window. It is the position of the second
hole.
NOTE: Press
or
to change holes number.
10. Process the holes 3rd –6
th
in the same way.
11. After processing all holes, press
to return normal display state.
NOTE: In the course of BOLT HOLE CIRCLE processing, pressing
(three axes display) or
X
Y
(two axes
display) can leave BOLT HOLE CIRCLE function temporarily and return normal display state in order to
check the position. And press
(three axes display) or
X
Y
(two axes display) again to return BOLT
HOLE CIRCLE function.
4.2
Bolt Hole Line
Function: SW4000 series DRO provides BOLT HOLE LINE (BHL) function. This function can
simplify the processing multiple holes whose centers are attributed equally on one line.
The following parameters are needed to be input:
LINE DIS Line distance (distance between the center of first hole and the center of the last
hole)
