SW4000 USER’S MANUAL
VER5.13 31
INCLE: Set machine plane XY, YZ or XZ plane
INCL.ANG: the inclination angle of the slope
MAX CUT: the slope length each time processing
Note:
Z STEP and MAX.CUT are defined as the figure.
DRO will calculate the position of each processing on
the slope automatically when all parameters have been input.
Press
or
to select the processing point and
process until “0.000” appears in the window.
Example 1:
Process the slope AB as the figure. The
parameters are as following:
INCLE: XZ
INCL.ANG 45°
MAX.CUT 1.2mm
STEPS:
1. Set display unit to metric;
Set the SLOP.MODE 1 in initial system settings.
Note: If the third parameter isn’t Z STEP, set the SLOP.MODE 0.
Move the machine table until the lathe tool is aligned
with the starting point A, then zero X axis and Z axis.
Press
,
in normal display state.
2. Press
to enter slop processing
Press
ENTER
to start processing directly if all parameter
have been set.
3. Select machine plane.
Press
Z
ENTER
in turn to select the XY plane.
Note: Press
X
indicates XY plane;
Press
Y
indicates YZ plane;
Press
Z
indicates ZX plane;
