LS ELECTRIC XGT Series, User Manual, Page: 54 / 804

Chapter 2. Basic Application
2-7
7) Monitor
Instruction Description
Start/Stop Monitoring Starts or stops the monitor.
Pause Temporarily stops the monitor.
Resume Restarts the monitor temporarily stopped.
Pausing Conditions Specifies conditions for the monitor temporary stop.
Change Current Value Specifies the device value being monitored.
System Monitoring Execute the system monitor.
Device Monitoring Execute the device monitor.
Special Module Monitoring Execute the special module monitor.
Trend Monitoring Execute the trend monitor.
PID monitoring Executes PID monitor.
SOE monitoring Executes SOE monitor.
Custom Events Specifies the custom events.
Data Traces Specifies the device to monitor the change of the data.
8) Debug
Instruction Description
Start/Stop Debugging Converts to Debug mode to Start/Stop Debugging.
Go Runs to the break point.
Step Over Runs step by step.
Step Into Debugs the subroutine.
Step Out Escapes from the subroutine.
Temporary Stop Stops Run.
Go to Cursor Runs to the cursor position.
Set/Remove Breakpoints Sets or cancels the break point.
Breakpoints List Displays the list of the break points specified.
Breakpoint Conditions Specifies the break conditions
9) Tools
Instruction Description
Network Manager Shows the PLC network and specifies the parameter.
Temperature control Executes the XG-TCON tool.
Position control Executes the XG-PM tool.
Address calculator Executes the address calculator.
Start simulator Starts the simulator.
ASCII code table Displays the ASCII code table.