LS ELECTRIC XGT Series, User Manual, Page: 367 / 804

Chapter 9. Parameters
9-2
a. Basic Parameters Settings: used to specify setting of basic operation, time and output control of [Basic
Parameters] information.
b. Fixed period operation: used to decide to run the PLC program based on the fixed period operation or
based on the scan time.
c. If (b) Fixed period operation above is checked, input the operation time in ms unit.
d. Assign Fixed Points to I/O slot (64): used to decide to assign fixed 64 points of memory to I/O slot or to let
it assigned freely by the program.
e. Watch Dog timer: used to specify the time value of the scan watch-dog timer to keep PLC from stopping
due to program error.
f. Standard input filter: used to specify the standard input value.
g. Output during debugging: used to decide to output the data to the output module as usual or not even
while being debugged.
h. Keep Output when an error occurs: used to decide to output the data to the module as usual or not even
when an error or a specific input occurs.
i. Keep Output when converting RUN->STOP converted: used to decide to output the data to the module as
usual or not even when PLC operation mode is converted from RUN to STOP.
j. Keep Output when STOP->RUN converted: used to decide to output the data to the module as usual or
not even when PLC operation mode is converted from STOP to RUN.
k. This is used to decide to delete the memory area with no latch specified in case an error occurs during RUN.
l. Exclusive function for event input module: refer to CH 19 event input module
m. Disable Reset switch: determines whether to disable the Reset switch of CPU module.
In case of disabling Overall Reset, only Overall Reset is disabled.
n. Disable Reset switch: determines whether to disable the D.CLR switch of CPU module.
In case of disabling Overall D.CLR, only Overall D.CLR is disabled.