LS ELECTRIC XGT Series, User Manual, Page: 395 / 804

Chapter 9. Parameters
9-30
[Description of dialog box]
a. Order: according to order, memory allocation is done in order from upper line to lower line.
b. Start: inputs start position of word device
c. End: inputs end position of word device.
d. OK: in case declared device changes, memory is allocated again and close dialog box
e. Cancel: doesn’t apply the changed device and close dialog box
f. Line add: adds device applied to memory allocation
g. Line Delete: delete device applied to memory allocation
h. Up: Changes the memory allocation order up.
i. Down: changes the memory allocation order down.
j. Basic parameter: shows basic parameter dialog box to change device area and latch status
Note
-
If one line is not effective, it is shown as pink color
-
D, M, T, C area are available for device auto-allocation area
-
One device can be set with diverse parts
-
Start device should be smaller than End device or equal
-
In case of timer, sets 4 types (0.1, 1, 10, 100ms) of timer auto-allocation area (TIMER0_1, TIMER1,
TIMER10, TIMER100 timer type)
-
For Latch 1 start, Latch 1 End, Latch 2 Start, Latch 2 End, refer to basic parameter information and
displays