Korg NAUTILUS Series, Parameter Manual, Page: 904 / 961

894
Source [List of Dmod Sources]
This selects a modulation source to control the Speed . For a
list of Dmod sources, see the “Dynamic Modulation Source
List” on page 910.
Amount [–10.0…+10.0]
This controls the depth and direction of the Speed
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
192: Vintage Flanger
A model of a truly classic analogue flanger. This amazing
stompbox’s bucket-brigade technology provides a sweeping,
whooshing sound, perfect for chords.
LFO
Speed [Hz] [0.10…10.00]
This controls the speed of the LFO.
Source [List of Dmod Sources]
This selects a modulation source to control the Speed . For a
list of Dmod sources, see the “Dynamic Modulation Source
List” on page 910.
Amount [–10.0…+10.0]
This controls the depth and direction of the Speed
modulation.
LFO Reset Source [List of Dmod Sources]
This selects a modulation source to reset the LFO. You can
use this to re-start the flanger’s jet-like, rolling motion just
before a big power chord, for instance. This will be most
useful when the
Speed is set relatively low.
Reset Offset Amount [0…100]
This controls the phase of the LFO when reset.
FLANGER
Depth [0…100]
Sets the depth of LFO modulation.
Source [List of Dmod Sources]
This selects a modulation source to control the Depth .
Amount [–100…+100]
This controls the depth and direction of the Depth
modulation.
Resonance [0…100]
This controls the intensity of the flanger effect, via feedback.
Manual [1…100]
This adjusts the offset of the LFO sweep, effectively
increasing the center delay time of the chorus.
When Depth is set to the maximum of 100 , this has no
effect.
Source [List of Dmod Sources]
This selects a modulation source to control the Manual
amount.
Amount [–100…+100]
This controls the depth and direction of the Manual
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
193: Red Comp
Need to play clean chordal passages with smooth, even
dynamics? Then, look no further: this compressor is
modeled on a pedal whose clean sound made it hugely
popular. Perfect for pop and funk music.
COMPRESSOR
Sensitivity [1…100]
This controls the amount of compression. Increasing the
value boosts lower level sounds, and raises the overall
volume.
To adjust the final volume, use the Output Level parameter.
Attack [1…100]
This controls the onset time of the compressor.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Flanger
LFO
Resonance
LFO Sync
Reset Offset
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Wet / Dry
Wet / Dry
+
Envelope - Control
Level
Compressor