Korg NAUTILUS Series, Parameter Manual, Page: 57 / 961

PROGRAM > Basic/X-Y/Controllers 1–6: X-Y Envelope
47
Time [0ms…60sec]
This parameter lets you set the Transition time in seconds
and milliseconds. It applies only when the Mode is set to
Time.
(Base Note) [Off… ]
This sets a basic rhythmic value for the Hold Time , relative
to the system tempo. The values range from a 32nd note to a
whole note, including triplets.
This parameter applies only when the Mode is set to Tempo .
x (Multiply Base Note by…) [01…32]
This multiplies the length of the Base Note . For instance, if
the Base Note is set to a sixteenth note, and the multiplier is
set to 3, the EG will move from Point 0 to Point 1 over a
dotted eighth note.
Points 1 and 2
Points 1 and 2 work exactly like Point 0, as described above.
Point 3
Point 3 also works much like Points 0–2, with two main
differences:
Point 3 always uses its own Time when moving into the
loop, regardless of the direction of the loop.
If Loop Repeat is set to Off, or if the number is set between
1–126 and has already played the specified number of times,
then the EG will stay at Point 3 until the EG either goes into
release.
Hold Time
This works just like the Hold Time for Point 0, as described
under “Hold Time” on page 46.
Loop
This sets the length of time that it takes to move from Point 3
to the first Point in the loop. You can set this in either
seconds/milliseconds or rhythmic values, depending on
whether the Mode is set to Time or Tempo.
The Time, Base Note, and Multiplier parameters work just
like those for Point 0, as described under “Transition” on
page 46.
Point 4
Point 4 is the X-Y Envelope’s release destination. Its time
setting is different from those of the other Points. Instead of
setting the time it takes to move from Point 4 to the next
Point, it sets how long it takes to go from the previous Point
to Point 4.
The EG moves to Point 4 as soon as it releases, regardless of
where it was before the release. For instance, let’s say that
the EG is in the middle of Point 2’s Hold Time at note-off.
The EG will immediately begin to move to Point 4, without
waiting for the Hold Time to complete.
Release
This sets the length of time that it takes to move to Point 4
after note-off. You can set this in either seconds/milliseconds
or rhythmic values, depending on whether the
Mode is set to
Time or Tempo.
The Time , Base Note , and Multiplier parameters work just
like those for Point 0, as described under “Transition” on
page 46.
v 1–6: Page Menu Commands
• Compare → p.112
• Write Program → p.112
• Exclusive Solo → p.113
• Copy Oscillator → p.119
• Swap Oscillator → p.119
• Copy X-Y Envelope → p.119
• PAGE → p.126
• MODE → p.126