Korg NAUTILUS Series, Parameter Manual, Page: 356 / 961

EXi: MOD-7 Waveshaping VPM Synthesizer
346
MOD-7 Tone Adjust parameters
In addition to the Common Tone Adjust parameters listed
above, the MOD-7 adds a number of its own parameters.
Note that these additional parameters are separate for each
EXi, as opposed to being shared by both EXi in the Program.
All of the additional parameters are listed below. Tone
Adjust parameters may affect the internal parameters in one
of two ways: they may be
Relative , in which case they scale
the existing parameter value, or Absolute , in which case
they over-write the existing value. Unless otherwise noted,
all of the MOD-7 parameters are
Absolute .
Macro Parameters
Brightness
Brightness Vel Sens
Timbre
Feedback
Detune
Noise
Saturation
Filter Freq
PCM Oscillator
On/off
MS Select
MS Bank
MS Min
MS Max
Start Offset
Reverse
Transpose
Tune
VPM Oscillators 1…6
On/off
Mode
Feedback
Ratio
Table
Drive
Output Level
Filters A and B
Type
Cutoff
Resonance
EG Int
LFO Int
LFOs
In addition to supporting the standard Tone Adjust LFO
parameters, the MOD-7 adds the following separate
controls:
• LFO 1 through 4 Waveform
• LFO 3 and 4 Speed
Step Sequencer
Attack Smoothing
Decay Smoothing