Korg NAUTILUS Series, Parameter Manual, Page: 605 / 961

SAMPLING > IFX 8–1: Routing
595
SAMPLING > IFX
Here you can make insert effect settings for use in
SAMPLING mode.
If you want to apply an insert effect IFX1–12 to the external
audio signal while you sample it, choose IFX1–12 as the
Bus
Select (IFX/Indiv.) (0–8a) parameter for Input1–4, and
adjust the parameters of the insert effect.
If you want to apply effects to a previously-sampled sample
or a sample you loaded, and resample the result, set the P8:
Insert Effect page “Bus Select (All OSCs to)” (8–1b)
parameter to IFX1–12, and adjust the effect settings.
(”Resample” 0–8c)
For instance, you can:
• Send the output of a multisample to an insert effect
• Route a sound to an insert effect
• Make detailed settings for insert effects
• Make common LFO settings for effects
For details on insertion effects, see “Effect Guide” on
page 729.
Insert effect settings for SAMPLING mode will revert to
the default settings when the power is turned off.
Use “Copy Insert Effect” if you want to keep your insert
effect settings. Select a program or combination, copy the
insert effect settings of SAMPLING mode, and save them.
Write the program or combination to save it in internal
memory. Then in SAMPLING mode, use “Copy Insert
Effect” to load the effect settings from the program or
combination so that they can be used in SAMPLING mode.
You can also use the “Save to User Preset” menu command
to save effects individually.
8–1: Routing
8–1a: Routing Map
Routing Map
This displays the status of the insert effect settings.
This indicates the input buses being sent to the insert effects,
the effects that are assigned, their on/off status, chaining, and
the output bus that follows the insert effect.
Use the SAMPLING > IFX– Insert FX page to select insert
effects, turn them on/off, and make chain settings.
8–1b: Bus Select
Bus Select (IFX/Indiv.Out Assign) (All OSCs to)
[L/R, IFX1…12, 1…4, 1/2…3/4, Off]
Selects the bus.
If you want to apply an effect to a sample (multisample) that
you sampled or loaded, select IFX1–12. (“Resample” 0–8c)
Note: After you resample, L/R will automatically be selected
as the “Bus Select (All OSCs to)” setting. These settings are
made automatically so that the effect will not be applied
again (i.e., a second time) when you play back the sample
that was resampled with the IFX. (In the same way, the
on/off settings for MFX1, 2 and TFX1, 2 will also be turned
off.) Be aware of this if you want to sample once again.
8–1PMC
8–1a
8–1b
8–1c 8–1d