Korg NAUTILUS Series, Parameter Manual, Page: 475 / 961

SEQUENCER > Home 0–9: Tone Adjust
465
0–9b: Tone Adjust Edit
Press the (EDIT) icon to edit the assignments and other
settings for the Tone Adjust function.
Sliders 1-8, 9-17
Assign [List of Tone Adjust assignments]
This lets you assign a Tone Adjust parameter to the sliders.
The first group of parameters are the Common set, which are
supported by most Program types. For a full list, see
“Common Tone Adjust Parameters” on page 31.
After the Common parameters, the items in the list will vary
depending on the Program type. For more information,
please see:
“HD-1 Tone Adjust Parameters,” on page 32.
“AL-1: Tone Adjust,” on page 180.
“CX-3: Tone Adjust,” on page 203.
“STR-1: Tone Adjust” on page 251.
“MS-20EX Tone Adjust parameters” on page 280
“PolysixEX Tone Adjust parameters” on page 295.
Other EXi instruments will have their own set of parameters,
as described in their manuals.
Assignments are exclusive
Each controller can be assigned to only one parameter, and
each parameter can be assigned to only one controller.
To swap a parameter from one control to another, you’ll need
to first un-assign it from the old control, and then assign it to
the new control.
Value [Depends on parameter]
This shows the current value of the parameter. The range of
values will vary depending on the parameter assigned to the
control.
Switches 1–16
Tone Adjust switches act a little differently than sliders.
When a switch is assigned to a Relative parameter, or an
Absolute parameter with more than two states:
Switch On = On Value (see below)
Switch Off = the Program’s stored value
When a switch is assigned to a two-state Absolute
parameter, such as Hold , the switch status directly reflects
the parameter value:
Switch On = On
Switch Off = Off
Assign [List of Tone Adjust assignments]
This lets you assign a Tone Adjust parameter to the switch.
For more information, see “Assign,” above.
On Value [Depends on parameter]
The parameter is set to this value when the switch is On.
When the switch is assigned to a two-state Absolute
parameter, such as Hold , this will always be the same as the
Switch Status (see below).
Switch Status [Off, On]
This simply shows whether the switch is On or Off.
v 0–9: Page Menu Commands
• Compare → p.112
• Memory Status → p.521
• Exclusive Solo → p.113
• Rename Song → p.521
• Initialize Song → p.522
• Copy From Song → p.522
• Load Template Song → p.522
• Save Template Song → p.523
• FF/REW Speed → p.523
• Set Location (for Locate Key) → p.523
• GM Initialize → p.523
• Copy from Combi → p.525
• Copy From Program → p.525
• Add To Set List → p.113
• Copy Tone Adjust → p.436
• Reset Tone Adjust → p.436
• PAGE → p.126
• MODE → p.126
If the old
Program is…
And the new
Program is…
Then Tone
Adjust
parameters
and values
are…
An HD-1 Program An HD-1 Program kept the same
An HD-1 Program
An EXi Program
loaded from
the new
Program
Any EXi Program
An HD-1 Program
loaded from
the new
Program
An EXi Program
An EXi Program
with the same EXi
assigned to the
same slots as the
previous Program
kept the same
An EXi Program
An EXi Program
which does not use
the same EXi as the
previous Program
loaded from
the new
Program