Korg NAUTILUS Series, Parameter Manual, Page: 108 / 961

PROGRAM mode: HD-1
98
PROGRAM > IFX
These pages let you can make settings for the insert effects.
For instance, you can:
• Send the output of a oscillator to an insert effect
• Route a sound to an insert effect
• Make detailed settings for insert effects
• Make common LFO settings for effects
For more information, please see “Effect Guide” on
page 729.
8–1: Routing
8–1a: Routing Map
This graphic shows an overview of the insert effects,
including the routing of the oscillators to the effects, the
effects names and on/off status, chaining between the
effects, and the output bus to which the insert effects are
themselves routed.
This page lets you adjust the routing of the oscillators to the
insert effects. To adjust the other settings shown in this
graphic, see “8–5: Insert FX,” as described on page 101.
Note: Configure the routing for the drum track in “Bus”,
Scene Common Setup on the ARP DRUM page. For more
information, see “Bus” on page 17.
8–1b: Use Dkit Setting
Use Dkit Setting [Off, On]
This is shown if Oscillator Mode is set to Drums or Double
Drums . If Oscillator Mode is set to Single or Double , it is
ignored. For more information, please see “Oscillator Mode”
on page 35.
On (checked): Drum Kits can have different Bus Select , FX
Control Bus , Send 1 , and Send 2 settings (GLOBAL 5–3b)
for each note. When Use Dkit Setting is On , these per-key
settings will be used. You can use this to apply individual
insert effects to specific drum instruments, or to send
specific drum instruments to individual outputs.
Tip: Most of the factory Drum Kits use standard Bus Select
settings, as detailed below:
Snares
→
IFX1
Kicks
→
IFX2
Toms → IFX3
Cymbals
→
IFX4
Percussion, etc. → IFX5
Off (unchecked): The Program’s normal settings for Bus
Select , FX Control Bus , and OSC MFX Send will be used;
see below for more information on these parameters. All
drum instruments will be sent to the same busses.
8–1PMC
8–1a
8–1d
8–1c
8–1b
8–1d 8–1e