Korg NAUTILUS Series, Parameter Manual, Page: 567 / 961

System Exclusive events supported in Sequencer mode Put Effect Setting to Track
557
System Exclusive events supported in Sequencer mode
You can record and play back System Exclusive events, and
edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in real-
time:
• Exclusive messages received from an external MIDI
device
• Parameter changes in SEQUENCER mode (see table
below)
• Master Volume universal exclusive messages assigned to
the foot pedal or a RT control knob
Parameter change messages that you can realtime-record in SEQUENCER mode
*1: Solo On/Off is always controlled by events in the track,
regardless of the play/mute status of that track.
The maximum amount of exclusive data that can be
recorded at once is approximately 320 Kbytes. This size
will decrease if other events exist within the same
measure.
You cannot simultaneously record exclusive messages
received from an external MIDI device and parameter
changes produced by editing.
If you record a parameter assigned to a control change
such as
Pan with the GLOBAL mode GLOBAL P1:
MIDI, MIDI Filter settings “Enable Control Change” and
“Enable Exclusive” both checked, edits you make during
recording will be recorded both as control change data
and parameter change data. These recorded events may
not be reproduced correctly if you rewind or fast-forward
during playback. If you want to record such events, check
only one of these two “Enable” settings in GLOBAL
mode MIDI Filter.
Front panel/Page Parameter
Front panel ARP/DRUM ARP, LATCH, DRUM buttons, RT Knob([Gate], [Velocity], [Length], [Swing], [Drum SD])
Home
MIDI Prog Mixer Program Select, Pan, Volume, PLAY/MUTE, Solo On/Off
*1
Audio Track Mixer Rec Source, Pan, Volume, PLAY/MUTE, Solo On/Off
*1
Audio In Sampling All “Audio Input” parameters
EQ/X-Y/
Controllers–
Controllers
MIDI Track EQ Auto Load Prog EQ, Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
Audio Track EQ Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
X-Y Volume
All “X-Y Volume Control” parameters, X-Y Assign, Center Volume, Enable Program X-Y
Volume
X-Y CC All “X-Y CC Control” parameters, Enable Song X-Y CC, Enable Program X-Y CC
X-Y Envelope All “Basic,” “X-Y Envelope Loop,” “X-Y Envelope” parameters
Set Up Controllers All “Panel Switch Assign,” “Modulation Knob Assign” parameters
Pads All “Pad Chord” parameters except “Enable Pad Play” and “Chord Assign On/Off”
Track Parameters
MIDI Track Priority
OSC Force OSC Mode, OSC Select, Portamento
Pitch Transpose, Detune, Bend Range, Use Program’s Scale, Type, Key, Random
Delay Mode, Time, Base Note, Times
WaveSeq ARP Key Sync, Swing, Quantize Trigger, ARP Track On/Off Control
Audio Track Delay Mode, Time, Base Note, Times
IFX
MIDI/Audio Routing1/2 “Bus Select, Send1, Send2, Fx Control Bus, Rec Bus
Insert FX IFX, IFX On/Off, Chain to, Chain, Pan, Bus Sel, REC Bus, Ctrl Bus, Send1, Send2
IFX 1-12 All effect parameters
Common FX LFO All “Common FX LFO 1, 2” parameters
MFX/TFX
Routing
MFX, MFX On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2, TFX, TFX
On/Off, Master Volume
MFX 1/2 All effect parameters
TFX 1/2 All effect parameters