10 Repair
80
10.6 Loading the system data
1.Switch on the power supply.
The following information is shown on the LDC display during the
start-up process:
System Startup
Processing
The transmitter is loading the sensory data and the transmitter
settings such as e. g: the measuring range, the damping and the
pulse width from the SensorMemory
*
.
2. The process display is indicated following the start-up
process.
3.
The flowmeter is ready for operation and will operate, as
ordered, based on either the factory default settings or the
preconfiguration requested by the customer.
To change the factory default settings, see
Parameterization
of the device
on page 37.
Note
Check the parameter settings for correctness.
* The SensorMemory is a removable memory module located at the rear of
the transmitter electronics module.
Summary of Contents for 406060
