JUMO 406060, Operating Manual

Page: 40 / 116

6 Commissioning
40
Easy Setup
Damping
30.00 ms
Next Edit
25.

Use to call up the edit mode.
26.

Use / to set the desired damping.
27.

Confirm the selection with .
Easy Setup
Dig.Out 41 / 42 Mode
Pulse
Next Edit
28.

Use to call up the edit mode.
29.

Use / to select the desired operating modeOff, Logic,
Pulse, Frequencyfor the digital output.
30.

Confirm the selection with .
Easy Setup
Curr.Out at Alarm
High Alarm
Next Edit
31.

Use to call up the edit mode.
32.

Use / to select the desired alarm mode.
33.

Confirm the selection with .
Easy Setup
Low Alarm
3.500 mA
Next Edit
34.

Use to call up the edit mode.
35.

Use / to set the desired current for Low Alarm.
36.

Confirm the selection with .
Easy Setup
High Alarm
21.800 mA
Next Edit
37.

Use to call up the edit mode.
38.

Use / to set the desired current for High Alarm.
39.

Confirm the selection with .
Zero point adjustment of the flowmeter
Note
Prior to starting the zero point adjustment, make sure that:
• There is no flow through the sensor (close all valves, shut-
off devices etc.)
• The sensor is completely filled with the medium to be
measured
Easy Setup
System Zero
Next OK
• Use
to start automatic adjustment of the zero point for the
system.
Menu
Easy Setup
Exit Select
Once all parameter have been set, the main menu appears again.
The most important parameters are now set.
40.

Use to switch to the process display.
Change from two to one column