10 Repair
77
10.3 Replacing the LCD indicator
A
Integral mount design
B
Remote mount design
1
Housing cover
2
Fastening screws for LCD display
3
LCD display
4
Connector
5
Four fastening screws for housing cover
Figure 51: Replacing the LCD display
Change from one to two columns
NOTICE
If the O-ring gasket is seated incorrectly or damaged, this
may have an adverse effect on the housing protection
class.
Follow the instructions in
Opening and closing the terminal
box
on page 22 to open and close the housing safely.
The LCD display can be replaced in the case of a defect.
Component Part
number
LCD display (HMI).
For integral and remote mount design
types
00706388
Follow the steps below to replace the LCD display:
1.
Switch off the power supply.
2.
Unscrew and remove the cover.
3. Loosen the fastening screws for the LCD display
(applicable to integral mount design only).
4.
Take off LCD display.
5.
Detach connector from motherboard.
6.
Insert connector of new LCD display. Take care not to
damage the cable harness.
7. Insert the LCD display and tighten screws as needed.
8.
Attach and screw on cover again.
9.
Switch on the power supply.
Change from two to one column
Summary of Contents for 406060
