JUMO 406060, Operating Manual

Page: 66 / 116

7 Operation
66
Menu / Parameters Description
Diagnostics / ...Diagnosis Control / ...Noise Check
Start Noise Check Used to start the noise check function with .
Power Spectrum Used to indicate the current power spectrum
Amplitude 1 Value Used to indicate the four strongest amplitudes in the power spectrum.
Amplitude 2 Value
Amplitude 3 Value
Amplitude 4 Value
Frequency 1 Used to display the frequencies associated with the four strongest amplitudes in the power spectrum.
Frequency 2
Frequency 3
Frequency 4
Diagnostics / ...Diagnosis Control / ...Fingerprints
Tx Factory CMR The “fingerprint” database integrated in the transmitter enables you to compare the values at the time of factory calibration or
commissioning with the currently recorded values.
As a result, changes can be detected early, and the appropriate measures can be taken.
Tx Factory 1m/s
Tx Factory 10m/s
Start Tx Customer FP Used to create the commissioning fingerprint for the transmitter with .
Tx Customer CMR The commissioning fingerprint is created on site during commissioning.
Use the “Start Tx Customer FP” parameter to create the commissioning fingerprint.
Tx Customer 1m/s
Tx Customer 10m/s
Diagnostics / ...Diagnosis Values
All of the values indicated in this menu serve information and service purposes.
Inhouse Temperature Used to display the temperature inside the transmitter housing.
Inhouse Temp MaxPeak
Inhouse Temp MinPeak
Driver Current Used to display the driver current for the sensor coils.
Signal Region on ADC Used to display the measured voltage at the input of the analog / digital converter.
Coil DAC Preset Used to indicate the setpoint for the digital / analog converter.
DC Feedback DAC Used to indicate the actual value for the digital / analog converter.
ADC Errors Used to indicate the number of A / D converter errors.
Device Restart Count Used to display the number of device restarts.