JUMO 406060, Operating Manual

Page: 64 / 116

7 Operation
64
Menu / Parameters Description
Input/Output / Dig.Out 51 / 52 / ...Setup Logic Output
Logic Output Action Used to select the binary output function.
Refer to the description regarding “Input/Output / Dig.Out 41 / 42- / ...Setup Logic Output”.
Active Mode Used to select the switching behavior for the binary output.
• Active High: Normally open contact.
• Active Low: Normally closed contact.
Default setting: Active High.
Input/Output / Dig.Out 51 / 52 / ...Alarm Config
General Alarm Used to select the error messages signaled via the binary output 51 / 52.
Available only if the “Logic Output Action” parameter was set to Alarm Signal.
Qv Volumeflow Max
Qv Volumeflow Min
EPD
7.5.7 Menu: Process Alarm
Menu / parameter Description
Process Alarm
Alarm history Display of the alarm history
Clear Alarm History Reset of the alarm history.
...Group Masking Selection of submenu ‘...Group Masking’ using .
...Alarm Limits Selection of submenu ‘...Alarm Limits’ using .
Process Alarm / ...Group Masking
Maintenance Required Alarm messages are divided into groups.
If masking is activated for a group (On), no alarm is issued.
For additional information, see Diagnosis / error messages on page 68.
Function Check
Out Of Specification
Process Alarm / ...Alarm Limits
Qm Massflow Min Set the minimum / maximum limit value (0 to 110 %) for mass measurement. If the process value ‘Qm [unit]’ exceeds or falls
below the limit value, an alarm is triggered.
Qm Massflow Max
Qv Volumeflow Min Set the minimum / maximum limit value (0 to 110 %) for volume measurement. If the process value ‘Qv [unit]’ exceeds or falls
below the limit value, an alarm is triggered.
Qv Volumeflow Max