Hyundai R 160 LC-3, Service Manual

Page: 438 / 459

8 - 125
DISASSEMBLY
Remove cylinder head and piston rod
Hold the clevis section of the tube in a
vise.
Use mouth pieces so as not to damage
the machined surface of the cylinder
tube. Do not make use of the outside
piping as a locking means.
Pull out piston rod(2) about 200mm(8in).
Because the piston rod is rather heavy,
finish extending it with air pressure after
the oil draining operation.
Loosen and remove socket bolts(22) of
the cylinder head in sequence.
Cover the extracted piston rod(2) with rag
to prevent it from being accidentally
damaged during operation.
Draw out gland(3) and piston rod
assembly(2) together from cylinder tube
(1).
Since the piston rod assembly is heavy in
this case, lift the tip of the piston rod(2)
with a crane or some means and draw it
out. However, when piston rod(2) has
been drawn out to approximately two
thirds of its length, lift it in its center to draw
it completely.
(1)
ڸ
Ɠ
ڹ
ں
Ɠ
ڻ
Ɠ
200
mm
2
22
Hexagon
socket wrench
Cover here
with rag
Oil pan
Lift
Full straight
sideways
2
3
1)