Hyundai R 160 LC-3, Service Manual

Page: 376 / 459

8-63
ASSEMBLY
Reassemble the drive shaft assembly.
Insert the bearing seal(915) in the drive shaft(201).
Install the roller bearing(401) in the drive shaft(201) after warming it up for about 10 minutes in
the oil can at 80~100
Ş
C(176~ 212
Ş
F).
Insert the oil seal(801) in the casing(102).
Insert the roller bearing(402) with snap ring(913).
Reassemble the drive shaft assembly in the casing(102).
Reassemble the ring gear(202) after applying grease to the casing(102).
Reassemble the No.2 carrier assembly(230).
Reassemble No.2 sun gear(204) with the side plate(287).
Reassemble the No.1 carrier assembly(231).
Insert the No.1 pin(285)with the spring pin(910) in the No.1 carrier(231).
Insert the spring pin(910) in the No.1 carrier.
Insert the side plate(287) in the center of No.1 carrier.
Insert the side plate(288).
Insert the side plate(285) with snap ring(911).
See the Table for the sizes of side plates.
Install the No.1 carrier assembly in the No.2 sun gear.
Install the No.1 sun gear(211) with snap ring(912).
Install the swing motor with bolts(602) in the ring gear(202) with grease.
Insert the drain plug(901) of the gear.
Reassemble the level bar(311) and pipe(312).
Give gear oil.
This completes assembly.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
ڸ
ڹ
ڸ
ڹ
ں
ڻ
ڼ
Ɠ
4)
Inner dia. Outer dia. Thickness
Item no.
mm in mm in mm in
285 45 1.77 59 2.32 2 0.08
286 50 1.97 64 2.52 1 0.04
287 42 1.65 95 3.74 2 0.08
288 45 1.77 59 2.32 1 0.04