Hyundai R 160 LC-3, Service Manual, Page: 328 / 459

8 - 15
ASSEMBLY
For reassembling reverse the
disassembling procedures, pay attention
to the following items.
Do not fail to repair the parts damaged
during disassembling, and prepare
replacement parts in advance.
Clean each part fully with cleaning oil and
dry it with compressed air.
Do not fail to apply clean working oil to
sliding sections, bearings, etc. before
assembling them.
In principle, replace seal parts, such as
O-rings, oil seals, etc.
For fitting bolts, plug, etc., prepare a
torque wrench or so on, and tighten them
with torques shown in page 8-10, 11.
For the double-pump, take care not to
mix up parts of the front pump with those
of the rear pump.
(1)
4)
ڸ
ڹ
ں
ڻ
ڼ
ڽ
Fit swash plate support(251) to pump
casing(271), tapping the former lightly
with a hammer.
After servo piston, tilting pin, stopper(L)
and stopper(S) are removed, fit them
soon to pump casing in advance for
reassembling.
In tightening servo piston and tilting pin,
use a protector to prevent tilting pin head
and feedback pin from being damaged.
In addition, apply loctite(Medium strength)
to their threaded sections. (2)
Ɠ
Ɠ