EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-006
B - 136
FASTP EMS 512 Text Messages
Effect.
The FASTP network print process abends and might create a ZZSA
nnnn
Saveabend file.
Recovery.
Use the Spoolcom DEV command to restart the device. (Depending on the
device configuration, the device might restart automatically.) If the error persists, or the
cause of the error is unknown, contact your service provider as described in
Troubleshooting and Reporting Problems
on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the FASTPTCP process.
Cause.
Because FASTPTCP processes are started automatically by the Spooler
supervisor using the name configured with Spoolcom PRINT, this message can only
occur when the FASTPTCP process has been improperly started. The most likely
cause is the TACL RUN command was inadvertently used.
Effect.
The FASTPTCP process stops.
Recovery.
Do not use TACL RUN commands for FASTPTCP processes; use the
normal Spooler mechanism as described in
Configuring a FASTP Network Print
Process
on page 2-4. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems
on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the process.
file-err
is the file-system error returned by the Guardian OPEN procedure. See the
Guardian Procedure Errors and Messages Manual
for explanations of file-system
errors.
supervisor
is the name of the Spooler supervisor process.
Cause.
Because FASTP network print processes are started automatically by the
Spooler supervisor using the name configured with Spoolcom PRINT, this message
proc-num
Print process must have valid spooler in IN file
proc-num
Unable to OPEN Spool Supervisor, Err:
file-err
on
supervisor